Telnet connection from core switch sub-switch
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-21-2017 12:53 PM
Hello 🙂
I have a extreme core switch (A) where an lwl cable is connected to another switch (B) (uplink port)
The switch (B) has no ip address yet. I can only access the switch if I connect directly with a notebook via the management port.
I can access the switch (A) via telnet 192.168.100.1
Is it possible that I can access switch (B) from switch (A) via telnet?
If yes, how can I do this?
I have a extreme core switch (A) where an lwl cable is connected to another switch (B) (uplink port)
The switch (B) has no ip address yet. I can only access the switch if I connect directly with a notebook via the management port.
I can access the switch (A) via telnet 192.168.100.1
Is it possible that I can access switch (B) from switch (A) via telnet?
If yes, how can I do this?
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-21-2017 03:40 PM
You may create temporary vlan on core switch and connect untagged port of that vlan to mgmt port on switch (B)
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-21-2017 01:05 PM
The switch needs an IP for the telnet connection.
# configure vlan XXX ipaddress x.x.x.x x.x.x.x
# configure vlan XXX ipaddress x.x.x.x x.x.x.x
