Upgrading firmware with an EAPS ring
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-05-2015 03:46 PM
I have to upgrade the firmware on 3 switches that have an EAPS ring running on them. When I reboot the switch will the ring just failover and then complete once the switch is back up? Are there any special considerations I should be aware of?
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-05-2015 03:49 PM
Great!
Thanks for the quick reply.
Thanks for the quick reply.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-05-2015 03:48 PM
You can upgrade these switches and reboot without causing any problems with the EAPS ring. The EAPS ring should re-converge after the switch comes up.
