when connected via console port getting error as System is in trial for 30 day(s) and this will expire in 7 day(s), X460-48t, EXOS
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-06-2017 05:16 AM
SW 1 & 2 are showing the following error when using the console port. Can you please advise why this trial licence warning is
appearing and is this potentially service impacting? NOTE: When logging in via SSH this warning is not seen.
SW-01.1 # exit
System is in trial for 30 day(s) and this will expire in 7 day(s)
login:
&
SW-02.1 # exit
04/04/2017 15:10:41.27 User ****** logout from serial
System is in trial for 30 day(s) and this will expire in 8 day(s)
appearing and is this potentially service impacting? NOTE: When logging in via SSH this warning is not seen.
SW-01.1 # exit
System is in trial for 30 day(s) and this will expire in 7 day(s)
login:
&
SW-02.1 # exit
04/04/2017 15:10:41.27 User ****** logout from serial
System is in trial for 30 day(s) and this will expire in 8 day(s)
10 REPLIES 10
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-06-2017 05:29 AM
Somyaranjan,
Am suspecting a trial license might be installed in the past and the switch wouldn't have been rebooted after clearing the trial license. Would it be possible for you to reboot only 1 switch and check if it is still logging the following message?
Am suspecting a trial license might be installed in the past and the switch wouldn't have been rebooted after clearing the trial license. Would it be possible for you to reboot only 1 switch and check if it is still logging the following message?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-06-2017 05:29 AM
Is there any solution apart from this, for reboot i need to check with customer approval and get back to you..
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-06-2017 05:26 AM
Could the trial license be enabled previously and cleared without the switch being rebooted ?
A reboot is needed after the trial-license is cleared.
A reboot is needed after the trial-license is cleared.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-06-2017 05:26 AM
Hi Oscark, No we have not enabled any license before... If so why we are not getting error while logged in via SSH.
