2017-04-03: New GTAC Knowledge Articles March 26 - April 1, 2017

[Ken_Thomas]

Here are the new articles that were published March 26 - April 01, 2017 in GTAC Knowledge:

Sunday, March 26, 2017:
What does the log " MSM-A: Accept failed 130: Software caused connection abort" mean?

Monday, March 27, 2017:
How to see command history on WiNG controllers/APs?
How to reset AirDefense ADSP default GUI admin user account
WiNG Failed to establish L2TPv3 tunnel
What's the maximum size of the username in EXOS?

Tuesday, March 28, 2017:
What is Acoustic Noise of B-Series and C-Series?
How to Collect LanPlanner Appliance Key
Unexpected reset -Thread Name: tArpPktRcv when vxlan is configured
404 Error: Cannot Submit a Case in the Extreme Portal
Summit 100FX Link issue with Source Photonics SPG-FE-FX-CDFC-EX
Kernel Oops when deleting port from VPLS service VMAN

Wednesday, March 29, 2017:
EMC AP Group Reporting
S-Series Fails to Backup BGP Peer
Set Max Number of devices allowed per User in Access Control
How to authenticate wired/third party AP clients on identifi controller?
Connection issue with Alcatel-Lucent OmniTouch 8118 WLAN Wiress phones after Firmware Upgrade

Thursday, March 30, 2017:
Client Can ping Everything but Devices on other VLANs Can Not Ping Back
Are EOS Switches Vulnerable to SNMP GetBulk attack Reported by NESSUS Tool?
Where can I find the Extreme WiNG antenna guide?
Unable to archive configuration error - The ability to archive configuration files for this device h...
During upgrade, radius timeout policy configuration fails when policy is not "treat-like-access-reje...

Friday, March 31, 2017:
SecureStack B5 upgraded to 681080005 resulting in failed Sha/AES SNMPv3 auth in NMS
How to configure ospf on a user created virtual router
Source ports will not mirror in different directions to more than one destination port at a time
AP is rebooting on 10.11 and 10.21 with multicast-to-unicast enabled on 2.4ghz
G3 I/O Module causes the switch to continuously reset in a loop condition
ip helper-address & ipv6 dhcp relay destination config lines corrupted
Upload and Restore configurations from switch using USB flash drive
What is the difference between "Standard" mode and "Enhanced" mode in the Stacking feature?

Saturday, April 01, 2017:
none