Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
09-12-2017 08:31 PM
Hi everyone
I'm a noob with Enterasys sws. Please need your help
We've 6 switchs (2 Cisco and 4 Enterasys A2) every switch is in a different IDF, We ́re in the segmentation process and we're created a VLAN 20 for Switchs Management, with the cisco we don't have any problem, but with Enterasys we don't have idea how to configure a IP ADDRESS in VLAN 20 to reach every Enterasys under this VLAN 20
Please somebody help me!
I'm a noob with Enterasys sws. Please need your help
We've 6 switchs (2 Cisco and 4 Enterasys A2) every switch is in a different IDF, We ́re in the segmentation process and we're created a VLAN 20 for Switchs Management, with the cisco we don't have any problem, but with Enterasys we don't have idea how to configure a IP ADDRESS in VLAN 20 to reach every Enterasys under this VLAN 20
Please somebody help me!
Solved! Go to Solution.
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
09-13-2017 01:23 AM
If you have different switches with VLANs and want to connect them together you have to set the egress state of the ports where the switches are connect together:
example: Switch A is connected with Switch B (let's say the uplink port between both is ge.1.1 then you have to:
- create the VLAN : set vlan create 20
- configure Data Host Port into vlan 20: set host vlan 20
- configure ge.1.1 to forward vlan 20 traffic tagged: set vlan egress 20 ge.1.1 tagged
- configure the ip address on both switches: set ip address 10.0.0.1 mask 255.0.0.0 gateway 10.0.0.254
At the cisco - I'm not sure - but I guess you have to set the port in trunk mode and allow vlan 20.
If you configure two Enterasys switches like the example and connect them together it should be possible to ping from one to the other.
Best regards,
Axel
example: Switch A is connected with Switch B (let's say the uplink port between both is ge.1.1 then you have to:
- create the VLAN : set vlan create 20
- configure Data Host Port into vlan 20: set host vlan 20
- configure ge.1.1 to forward vlan 20 traffic tagged: set vlan egress 20 ge.1.1 tagged
- configure the ip address on both switches: set ip address 10.0.0.1 mask 255.0.0.0 gateway 10.0.0.254
At the cisco - I'm not sure - but I guess you have to set the port in trunk mode and allow vlan 20.
If you configure two Enterasys switches like the example and connect them together it should be possible to ping from one to the other.
Best regards,
Axel
5 REPLIES 5
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
09-12-2017 10:45 PM
Are you running your management in vlan 20?
Try
set host vlan 20
Try
set host vlan 20
