entrasys matrix v2124-24+switching+password

[YoungSang_Kim]

Old equipment going to the Entrasys Matrix V2H124-24 password reset.

I would like to know how to initialize the slip ratio of the "admin" account.
Or I would like to know how to initialize.

Thank you, please help.

--------------------------------------------------------------------------------------------------
Image Loader 1.0.0.3SDRAM Test(1MB)................ PASS
Loading Diagnostic Image File : ES3526V_60DiagV1.1.0.3.bix

Diagnostics 1.1.0.3
MAC Address : 0001-F492-7920
Serial Number : 03411071210B
Service Tag : 0000000
Hardware Version : R02
Manufacture Date : 2003-11-04
Project ID : 89
Board ID : 0
Now is Normal Mode!
--- Performing Power-On Self Tests (POST) ---
UART Loopback Test......................PASS
Timer Test..............................PASS
DRAM Test ..............................PASS
I2C Initialization......................PASS
Runtime Image Check ....................PASS
PCI Device Check .......................PASS
Switch Driver Initialization............PASS
Switch Internal Loopback Test...........PASS
------------------- DONE --------------------

[Straw__Glyn]

I think you are asking how to reset the password on a V2 series. The following article in our knowledgebase will give you instructions of how to achieve this

Browser View: https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-execute-a-Password-Recovery-on-the-...

Mobile View: https://gtacknowledge.extremenetworks.com/pkb_mobile#article/How_To/kA1800000008Z0DCAU/s

Basically, you will need to get the mac address of the switch and call into GTAC so that they can generate a backdoor password specific to that switch.

There is no other default procedure