Extreme Summit 400-48 port stuck on boot

[victor_miranda]

When i boot my Extreme Summit 400-48 port it hangs. When i connect serial cable it display Decompressing primary image from flash ..........................................+
It gets stuck after the + sign. It stays there forever. I try going into bootrom by pressing space and selecting primary image or secondary image or primary code or secondary code and they all get stuck on decompressing image from flash. I have also try reset same thing

Any though

[Bhagyesh_Lodha]

any update on this one ? I am seeing similar issue on 2 Summit 400's.

[Drew_C]

If you're seeing this issue as well, it is very likely some type of hardware failure. The S400 is quite old at this point, at least 10 years for most of them.

[victor_miranda]

No, it was on stack mode with 2 other summit 400, when we close the colo we just turn them off and move to our office, Sold the other two and now I wan to use this switch and it gives that error. I also see on the back that both stack lights are stady on green. I have also try upload image using xmodem upload and it just get stuck as well, it never finish. When I go to bootrom and press h for help all that works. Hopefully is not a hardware failure.

[Paul_Thornton]

I hate to give you bad news, but every time I've had a switch behave like that, it has been a hardware failure.

Did you do anything like try and upgrade the firmware before having this problem?