Extreme Networks

Paul_Thornton · 10-31-2019

HiI’m trying to achieve a simple “map to role based on RADIUS response” setup - there is a single SSID, and I want to place this into either a ‘access_filtered’ or an ‘access_normal’ VLAN. The filtering is all done externally, so as far as the wirel...

Paul_Thornton · 02-06-2018

I have an AP3805i in our lab that we use when troubleshooting customer wireless issues - it gets connected up to their controllers so we can connect to the wifi and (hopefully) fix things. This morning I've run into an issue where it refuses to upda...

Paul_Thornton · 08-14-2017

We have purchased some training units ("TR-ELT-EMEA") and I have a certificate number for these. On the certificate it seems to suggest going to the old training webpage and registering, but I can't find anything on the new education portal where we...

Paul_Thornton · 07-05-2017

Hi all Before I open a TAC case about this, I'm just trying to find out if anyone else is doing something similar and has the same issue. Somewhat simplifying, I have four devices physically connected like this: [ Cisco 1 ] -------- [ X460G2 "RX1"...

Paul_Thornton · 11-16-2016

Hi all I'm trying to (unsuccessfully) work out from the datasheet how much power is available for PoE on an X440-G2-48p without the additional RPS connected. This is well documented on the X450-G2 datasheet for the X450-G2 product set, but it seems...

Paul_Thornton · 11-01-2019

A followup for the archives.When I was creating the role, I hadn’t selected ‘Containment VLAN’ - I was using the advanced option to set the VLAN. This didn’t work.Once configured correctly, setting the Filter-Id to the role’s name just works as expe...

Paul_Thornton · 10-23-2018

Interesting this question came up - I was about to post about a near identical setup. The benefit I see of this "back to back" MLAG is that both sides just see a LAG, so you have a true active-active situation for traffic in either direction. The a...

Paul_Thornton · 10-18-2018

Showing my time on EXTR kit ... "Herb said 'where is everybody'" and "Everybody said 'where is Herb'"  Also there was the fun Easter egg where it randomly gave the running temperature in Kelvin.

Paul_Thornton · 07-13-2018

Your PC looks like it doesn't have a route for 20.20.20.0/24. And the other PC doesn't have a route for 10.10.10.0/24, even though you have it set. I think the packets are going out to the Internet and then timing out there. do a 'route print' on ...

Paul_Thornton · 05-24-2018

I'm still confused why you are using both MAC addresses and IP addresses in this filter. Does it work if you remove all of the ethernet-source-address lines? Paul.

Extreme Networks

User Statistics

User Activity

Single SSID mapping to multiple topologies not working as expected

Manual AP upgrades

Converting/using training EDUs

IPv6 forwarding issue with OSPFv3 in a user VR

X440-G2 PoE capacity

Re: Single SSID mapping to multiple topologies not working as expected

RE: Topology: MLAG

RE: Extreme's Self-Aware Equipment

RE: TTL expired in transit!

RE: ACL in EXOS