ISW 16804 Configuration
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-12-2017 05:57 PM
I am brand new to the Extreme Switch 16804 and I'm not a router guy
Going through doing basic configuration, IP config
Mode - Host or Router ?
Reading through the config guide it says Host mode won't route traffic through any port
Popup Help window is useless
Search for Youtube videos is a total waste of time, frustrated
Can anyone explain which mode this switch should be in, it's purpose is to sit at each end of a wireless link and pass vlans and QinQ
Also how do I specify a gateway for the NTP ?
Dave
Going through doing basic configuration, IP config
Mode - Host or Router ?
Reading through the config guide it says Host mode won't route traffic through any port
Popup Help window is useless
Search for Youtube videos is a total waste of time, frustrated
Can anyone explain which mode this switch should be in, it's purpose is to sit at each end of a wireless link and pass vlans and QinQ
Also how do I specify a gateway for the NTP ?
Dave
18 REPLIES 18
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-14-2017 04:05 PM
no example in the manual
I want the gateway on vlan 99 to 10.10.41.1
What does that look like
I want the gateway on vlan 99 to 10.10.41.1
What does that look like
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-14-2017 04:03 PM
Hi Dave,
you can try the "Add Route" button to add a default route.
Erik
you can try the "Add Route" button to add a default route.
Erik
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-14-2017 03:57 PM
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-14-2017 02:33 PM
If you want to configure the default gateway from the GUI, it is on the Configuration > System IP page. There is a "Default Gateway" box near the bottom of the page. This is where you would enter the gateway.
Please see the following page for details on the IP configuration:
http://documentation.extremenetworks.com/industrial_switches/web_config/Industrial_Switching/Web_Use...
Please see the following page for details on the IP configuration:
http://documentation.extremenetworks.com/industrial_switches/web_config/Industrial_Switching/Web_Use...
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-14-2017 08:01 AM
Hi Dave,
it seems you can set a default route using the "ip route 0.0.0.0 0.0.0.0" CLI command in configuration mode. See http://documentation.extremenetworks.com/industrial_switches/CLI/Industrial_Switching/CLI_Guide/r_ip....
I did not see an "ip default-gateway" command in the docs, that command would be the one to use on a Cisco IOS layer 2 switch. The ISW CLI seems to be similar to Cisco IOS (also known as "industry standard CLI").
Erik
it seems you can set a default route using the "ip route 0.0.0.0 0.0.0.0
I did not see an "ip default-gateway" command in the docs, that command would be the one to use on a Cisco IOS layer 2 switch. The ISW CLI seems to be similar to Cisco IOS (also known as "industry standard CLI").
Erik
