Port partitioning 2x50G problem on 7720-32C

[lucasfyn]

Hi every one

According to the documentation, the 7720 switch supports port partitioning 2x50G. However, when I enter the configuration command, it displays the following message:

Port 1:1 does not support port partitioning mode 2x50G

Please guide me on whether this feature actually exists or not. If it does, how can I configure it?

Thank you.

[Gabriel_G]

Could you link the document that states 2x50G is supported? I cannot seem to find that in the datasheet.

I also noticed that there are no 2x50G Breakout cables supported on the 7720 on the optics website.
It could be that this support is coming in a future release, but since there are no qualified cables, it may not be supported yet?
optics.extremenetworks.com