I received a SR2024 from a Friend and was told there was a GUI i could access however i cannot for the life of me figure out how to access it (HELP PLS)
From this earlier post I read that there is no webUI, all access must be done via cli. Not an expert on this, just did a little looking around. Hopefully this helps. If you can reset the switch you should be able to access the cli.
From this earlier post I read that there is no webUI, all access must be done via cli. Not an expert on this, just did a little looking around. Hopefully this helps. If you can reset the switch you should be able to access the cli.
