USB to Serial Adapter
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-03-2013 08:10 PM
Does anyone have a recommendation for a good USB to Serial adapter that works well with Windows 8.1?
5 REPLIES 5
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-09-2019 03:28 PM
I've got the same driver version. Only difference I see is under advanced com3 settings, mine says flow control none.
I'm assuming you are using the console cable that came with the switches?
I'm assuming you are using the console cable that came with the switches?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-08-2019 04:52 PM
I forgot to mention that after uninstalling the driver, deleting the driver, and then installing the driver again, that I tried to console to the switch again, but no luck.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-08-2019 04:48 PM
Yes, I installed the drivers a while back for the cable. Just today, I uninstalled the drivers and installed the drivers again from Startech. I am using driver version 2.12.28.0, which is the latest on Startech's site. Attached are screenshots of Device Manager and PuTTY. Any thoughts? Perhaps I have a bad cable? I will be out of the office for about a week, so I will respond back after that as soon as I can. Thanks for the help.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-06-2019 06:52 PM
I use the FTDI chipset usb to serial, and works great, haven't had an issue. Did you load the drivers for the cable?
