VSP-4000 port clocking up HCInFlowCtrlPkts
Hi, When graphing an up link port we are seeing HCInFlowCtrlPkts increasing can offer any advice why we are seeing this? The port is not very busy. It’s copper port running at 1Gb. Many thanks
Forum Posts
Resolved! Tagging Vlan on LACP on VSP8600
Hello All, interface gigabitethernet 1/1 lacp aggregation enable lacp enable lacp key 10 lacp mode passive interface gigabitethernet 1/2 lacp aggregation enable lacp enable lacp key 10 lacp mode passive I think I done the lacp config, but I need t...
Resolved! SMLT and MLT VLAN + LACP configuration confusion
Hi, Hoping someone can provide some assistance in understanding SMLT / MLT configuration on a VSP8600. I have a scenario where I’m migrating some EOS cores with VSPs one at a time, and I initially need to support STP to the egde. To do this I ini...
Resolved! VOSS - Can't add multiple VLANs to a port or VLANs to an MLT or port from VLAN!?
Hi, Appreciate this could be a straight forward question, its for a VSP8600 version 6.3.2.0. The system has been configured using the simplified vist (it was requested) As part of the configuration I need to add VLANs to MLT interfaces like so: m...
Resolved! VOSS 8600 config so fractured its hard to read
Hi, I’m finding the configuration on the VSP8600 very fractured and hard to read, and thereby hard to configure and fault find, on top of that there is no pipe command. Here is an example below…. if I need to configure an interface / port it is ref...
