ExtremeSwitching (VSP/Fabric Engine) - Page 107 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Resolved! ERS 4850 stuck fw 5.65

I have purchased some used Avaya Ethernet Routing Switch 4850GTS-PWR+, however they are on: HW:12 FW:5.6.0.18 SW:v5.6.3.024 BN:24 I need the software image for 5.6.5 or 5.7 and diagnostic image 5.8.0.01 or 5.8.0.03 then I can download the rest from...

ERS4900 - dhcp-snooping trust NNI interface

Hi folks, In switch/stack ERS4900 with SPB config, when you configure dhcp-snooping, do the NNI interfaces have to be set to trusted like an uplink port in legacy networks? Regards, EF

ACL migration from Nortel ERS-8800 to VSP

Hey Everyone, We are migrating from our ERS-8800's to new VSP switches and I seem to be having issues with the new ACL configuration. Previously it was set to: filter acl 50 create inPort act 4092 name "PolicyName" filter acl 50 ace 97 create name...

disconnected: protocol error: rcvd type 0 (2)

I'm trying to get config from the switch using oxidized, but my switch gives an error message: "disconnected: protocol error: rcvd type 0 (2)" I'm not sure what causes this error, my ERS switches does not have this problem. The log below is from a V...

[VSP-8404] ip prefix-list

Can someone explain the basics of how an ip prefix-list works? Looking to deny the 239.255.255.250 from entering into the spbm multicast routing table. From what I've read it appears to be an allow list, so I would need to allow all other addresses w...

Top Kudoed Authors

User

Count

34

18

18

17

7

GTM-P2G8KFN