FABRIC ENGINE - MLT BANDWIDTH CALCULATION
Hi Team,how can I see/calculate MLT bandwidth utilization? I doesnt matter via CLI, GUI or using XIQ-SE tools.RegardsEF
Forum Posts
VSP VOSS Debug
How do I debug the following on VSP VOSS firmware v8.0 series:1. Debug traffic going to a destination?2. Debug IS-IS traffic?3. Debug SPBM traffic?I found myself with:trace flags isis tx-hello 1trace flags isis rx-hello 1But don't understand how to r...
BFD on Static Route between Fabric Engine and Alcatel
Reaching here but wondering if anyone has this setup:My Switch - Universal 5520 48T Running Fabric EngineVendor Switch - Alcatel Omniswitch 6860Goal - Enable BFD Session on a static route for sub second failoverThe vendor is being unhelpful and claim...
Resolved! Extreme core switch and Top of rack switches
Hello Community,I have a setup question. I have 2 sites with and Extreme 8404 core switch at each site.I have 2x top of rack switches in a port channel on each site going into their respective Extreme core ports.However, I do not have a core connect...
Breakout cables and port number
Maybe it's a stupid question, but for example with a 1x40G -> 4x10G copper breakout cable, how do you tell from the four SFP+ ends of the cable which will become port 1/x/1, 1/x/2, 1/x/3 and 1/x/4, respectively? I mean without trying. I could not fin...
