Hello, i’m looking for loop prevention by set priority spanning tree on interfaces to connect to switch core but it not working. i set the following on interface but the root port still on other way when i put “show spanning rstp status”. interfac...
Hi all, I’m doing some ECMP test in GNS3 using VSP’s (v8.1.0.0 image). Setup: The Cisco is advertising 192.168.1.1/32 via OSPF to VSP1 and VSP2. VSP1 and VSP2 redistribute OSPF into ISIS using a route-map wich sets the metric to 5000, so I can ...
Hello, i wanted to know if there a limitation on SPT mode’s when i connect tunnels via ISIS to extend VLAN’s, i wanted to change the actual Spanning Tree MSTP to RSTP. Thanks!, Joan Ale
Hi. Does anyone have standards/config for a VSP cluster connection to 3rd party switch cluster with LACP? The 3rd party will be HP/Aruba or Dell switches. I see some loops when 1 of the 3rd party switches are rebooted. Any ideas perhaps? Thx.
Can some one share the sample command output of show running-config verbose for Avaya ERS and Avaya VSP switches. I am a freelancer researcher so would like to know more about the device configuration
