ERS4900 - dhcp-snooping trust NNI interface
Hi folks, In switch/stack ERS4900 with SPB config, when you configure dhcp-snooping, do the NNI interfaces have to be set to trusted like an uplink port in legacy networks? Regards, EF
Hi folks, In switch/stack ERS4900 with SPB config, when you configure dhcp-snooping, do the NNI interfaces have to be set to trusted like an uplink port in legacy networks? Regards, EF
Hey Everyone, We are migrating from our ERS-8800's to new VSP switches and I seem to be having issues with the new ACL configuration. Previously it was set to: filter acl 50 create inPort act 4092 name "PolicyName" filter acl 50 ace 97 create name...
I'm trying to get config from the switch using oxidized, but my switch gives an error message: "disconnected: protocol error: rcvd type 0 (2)" I'm not sure what causes this error, my ERS switches does not have this problem. The log below is from a V...
Can someone explain the basics of how an ip prefix-list works? Looking to deny the 239.255.255.250 from entering into the spbm multicast routing table. From what I've read it appears to be an allow list, so I would need to allow all other addresses w...
Hi all, I am wondering if anyone here has experience with the following situation. I have 2 VSP switches setup as a vIST cluster. Towards each of these VSPs I have a Juniper router which is running ISIS. The routers are interconnected as well which ...
User | Count |
---|---|
32 | |
18 | |
16 | |
15 | |
7 |