Hello. I am trying to monitor our VSP devices with Zabbix and the Extreme Template (EXOS) does not fully translate over 100% on all OID's. I have managed to work out all the other OIDs that were incorrect, but the last one I am stuck on is CPU utilis...
Hello,I have a project where we need to add an "external" (outside) and very compliant zone to a fabric.If possible I simply want to use SPB to interconnect with the existing network, as constructing a redundant interconnect using the overlay is more...
Hey teamI am running Forescout as a NAC and when a client via Dot1x gets access to the network and Forescoute sends a CoA message i se the switch accept it but its no kicking out the client until i remove the cable and put it back in. Sometimes mulit...
I was able to get the virtual-ist up and running in the GNS3 environment using the new 9.2 image. Oh I was so happy. But, alas it stops working after a couple of minutes. If we reset the switch it comes up and then a couple of minutes later it goes d...
We have pairs of N7K and N9k connecting via eigrp (full mesh), each one of the pair connected to two mpls routers, each pair have routing table, I am looking to replace the routed interfaces between pairs of N7K and N9K with vPC, is that possiable ? ...
