Extreme VSP to Cisco VLAN trunking

[MJS]

Looking to trunk some vlans between a Cisco Catalyst switch and an Extreme VSP switch. Not having any luck. Here is the Cisco side:

interface GigabitEthernet1/0/52

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 103, 105, 110

switchport mode trunk

What would be the configuration of the port on the Extreme side?

Any help would be greatly appreciated.

[MJS]

@Martin Sebek 

Thank you sir. Worked perfectly.

[MJS]

Dang it. On my cell phone  Not sure how I marked my answer as the solution. Once I get back to my laptop I will see about resolving this. Ugh.

[MJS]

Thanks Martin. I will give this a try first thing tomorrow.

[Martin_Sebek · Accepted solution]

For example for configuring port 1/1 as trunk use following commands.

conf t

interface GigabitEthernet 1/1
encapsulation dot1q
untagged-frames-discard
default-vlan-id 0
exit

vlan members add 103 1/1
vlan members add 105 1/1
vlan members add 110 1/1

exit