Interface spanning tree change confirmation ?

[Extreme_Learner]

Apologies if this a stupid question. I am changing the config on some of the ports on our core VSP switches and I think I have this right but I would like some confirmation if someone could help?

Current port config :-

spanning-tree mstp edge-port true

What I am intending on changing to :-

no spanning-tree mstp  force-port-state enable

Message When issuing the commands:-Disabling CIST would also disable all other MST instances.Are you sure you want to continue (y/n) ?

From what I’ve read this is correct and I should choose Y however I wanted to confirm this would not effect any other ports when I do this ? 

(ref https://extremeportal.force.com/ExtrArticleDetail?an=000061137# )

Thanks for any help 

[Extreme_Learner]

Hi 

Thankyou for the previous answer. I’m left slightly perplexed as i thought it would change the spanning tree on the port however it seems left with it both on and off in the config ?

interface GigabitEthernet 1/10
tagged-frames-discard enable
name "Physical DC"
no shutdown
slpp packet-rx
slpp packet-rx-threshold 75
lacp key 10 aggregation enable timeout-time short
lacp enable
spanning-tree mstp edge-port true    
no spanning-tree mstp  force-port-state enable
exit

[Extreme_Learner]

Many Thanks

[Dilraj_Singh_Kh · Accepted solution]

If you run the command while being under the interface mode then it will only affect that particular port and not the complete switch.