cancel
Showing results for 
Search instead for 
Did you mean: 

MLAG issue

MLAG issue

Alok_Shukla
New Contributor III
we want to createing MLAG between 2 switches X620. During MLAG creation does IP of all VLAN between 2 switches be same using or same subnet range using.
Suppose that 2 switches(X620) we have and we have 5 vlan and there vlan-IP applied on switch-1. Does IP of all vlan's of switch-1 would be same using on switch-2 or any same subnet range.
Switch-1(X620)
VLAN2=192.168.1.2
VLAN3=10.10.10.1
Switch-2(X620)
VLAN2=192.168.1.2
VLAN3=10.10.10.1
13 REPLIES 13

Erik_Auerswald
Contributor II
Hi Alok,

with MLAG you do not define a root bridge. You define a root bridge for STP, but EXOS does not allow the use of STP on an MLAG port.

Thanks,
Erik

Alok_Shukla
New Contributor III
How do we create root bridge for Switch-A to vlan-1 and root bridge for Switch-B to vlan-2 in MLAG?

Andrew_Imam
Extreme Employee
Hi Alok,

If you intend to configure/enable VRRP on each of the MLAG peers to provide Layer 3 Gateway Redundancy, then for each VLAN you can assign a unique IP address and configure another IP address to be used for VRRP (the same IP on both switches). For example:

Switch-1(X620)
VLAN2=192.168.1.2/24 /VRRP IP=192.168.1.254/24
VLAN3=10.10.10.2/24 /VRRP IP=10.10.10.254/24
Switch-2(X620)
VLAN2=192.168.1.3/24 /VRRP IP=192.168.1.254/24
VLAN3=10.10.10.3/24 /VRRP IP=10.10.10.254/24

As part of your network design, you would need to determine whether you want to setup VRRP with one switch as the VRRP master and the second switch as the VRRP Backup or you would like to have Active-Active VRRP.

Please let us know if you have any other questions.
Thank you.

Best regards,
Andrew

You don't, MLAG uses all links at the same time. STP is not supported on MLAG ports on EXOS, see e.g. "Can I combine MLAG and STP?".
GTM-P2G8KFN