I've set up a spare VSP4850GTS unit that we have, which is connected to a 8404 core via SPBM.
Although the VSP4850GTS has an adjacency with the core and I can ping the device, its not accepting SSH connections, despite the boot flags being set and SSH being enabled. I updated the software just in case it was a software bug, but still no luck.
I did a factory reset on the device after which the device accepted connections, but would not log in with defaults of rwa/rwa
I then added another account with rwa privileges, after which the device would not respond to SSH.
I'm puzzled as to why SSH is failing, is there another command I'm missing?
Below are relevant snips from the VSP's config
# box type : VSP-4850GTS
# software version : 7.1.9.0
# BOOT CONFIGURATION
#
boot config flags ftpd
boot config flags sshd
boot config flags telnetd
#boot config sio console baud 9600 1
# end boot flags
# SSH CONFIGURATION
#
ssh timeout 120
ssh
#show ssh global
*******************************************************************************
Command Execution Time: Fri Dec 17 08:40:47 2021 UTC
*******************************************************************************
Total Active Sessions : 0
version : v2only
port : 22
max-sessions : 4
timeout : 120
action rsa-host key : rsa-hostkeysize 2048
action dsa-host key : dsa-hostkeysize 1024
rsa-auth : true
dsa-auth : true
pass-auth : true
keyboard-interactive-auth : false
sftp enable : true
client enable : true
enable : true
authentication-type : aead-aes-128-gcm-ssh aead-aes-256-gcm-ssh hmac-sha1 hmac-sha2-256
encryption-type : 3des-cbc aead-aes-128-gcm-ssh aead-aes-256-gcm-ssh aes128-cbc aes128-ctr
aes192-cbc aes192-ctr aes256-cbc aes256-ctr blowfish-cbc rijndael128-cbc
rijndael192-cbc
key-exchange-method : diffie-hellman-group1-sha1 diffie-hellman-group14-sha1
#show cli username
*******************************************************************************
Command Execution Time: Fri Dec 17 08:43:02 2021 UTC
*******************************************************************************
=============================================================
UserName AccessLevel State Type
=============================================================
ro ro enable default
rw rw enable default
rwa rwa NA default
I am trying to SSH to 192.168.251.7
mgmt vlan 2501
ip address 192.168.251.7/24
ip route 0.0.0.0/0 next-hop 192.168.251.254 weight 200
enable
exit
