VSP 8400 - Stuck on Status amber blinking - No output on console
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-03-2019 07:00 AM
We have factory default our CoreSwitch2 - VSP 8400, after the factory default no cli output on screen and stuck on Status=Amber blinking. Anyone could help our issue. Thank you.
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-12-2019 08:50 AM
Same on my problem, may I know what is the possible causes of this issue. can you explain? thank you
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-06-2019 11:36 AM
If you are able to see CLI outputs on switch bootup process then it might be possible to recover without RMA. If not then replacement is needed.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-04-2019 03:15 PM
What console setting are you using? The default baud rate for VSP 8400 is 9600. It your console is working with other switches but not this one, I am afraid it is broken and you have to RMA it.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-04-2019 02:14 PM
Hi Eric,
First question would be: What was the reason for Factory Defaulting the box ?
Second Question: Was it working fine before factory defaulting it?
Regards,
DILRAJ
First question would be: What was the reason for Factory Defaulting the box ?
Second Question: Was it working fine before factory defaulting it?
Regards,
DILRAJ
