cancel
Showing results for 
Search instead for 
Did you mean: 

AP blinking (LED status) checking status

AP blinking (LED status) checking status

a_huerzeler
Contributor

Hi all, 

with the newer Wifi 6 APs (305C,410C,510C) i would like to know if i can check with a CLI command the reason why an AP status led is blinking. I know they do that if there is a PoE issue but I had cases were they stopped blinking after i placed them on the map and send a Delta update. 

My question: Can i check by command what the status of the LED light is (stable/blinking and the reason why)?

Best, 

Andi

1 ACCEPTED SOLUTION

Christoph_S
Extreme Employee

Hello Andi,

 

Please try cli command: #show system led

 

Example:

AP305C-Internal-Mesh#show system led
Brightness configuration: bright

System LED status:
No Led Colour Blinking
---------------------------------------------------------
1 Power Off No blinking
2 Status White No blinking

 

You can refer to the AP manual for details on LED status for example:

The following is an excerpt from the AP305C/AP305CX manual:

  • White, Steady : The device has a CAPWAP connection to ExtremeCloud IQ and is operating normally.
  • White, Slow-blinking: The device has a CAPWAP connection to ExtremeCloud IQ, but is operating on 802.3af power instead of 802.3at power.
  • Amber, Steady: The device is initializing, rebooting, or is running without a CAPWAP connection.
  • Amber, Slow-blinking: The device has no CAPWAP connection to ExtremeCloud IQ, and is operating 802.3af power instead of 802.3at power.
  • Amber, Fast-blinking: The device is upgrading its IQ Engine firmware.
  • Dark: Power is off.

Thank you,

Christoph S.

View solution in original post

5 REPLIES 5

JoshC2
New Contributor II

Any reason an AP410C-1 would blink red? White, then amber, then red, then dark.

GTM-P2G8KFN