b@AP unable to see ssid

[Carlo_Alviar]

Hi i configured a WS3825i AP with a use of a C35 controller. I created a topology b@AP. i followede every steps in the gtac guide and also used VNS wizard more than once to do this policy in the AP. But everytime the AP is restarting to collect the policy created it didnt broadcast any SSID I created. I was planning to deploy this AP in a remote site where there is no wireless controller available. Could anyone of my seniors here help me with my concern? Thank you in advance.

[Gareth_Mitchell]

Hi

In the AP availability report is the AP now green?

Did you create a VNS, I didn't see a screenshot for that?

-Gareth

[Carlo_Alviar]

Hi i configured the AP to have an IP address thru its CLI but it didnt adopt to the command so i placed a static on the AP thru the Controller GUI. And after placing the IP on the AP no changes have happen. The AP cant still broadcast a SSID. Please see attached image.

[Ronald_Dvorak]

Yes & no 🙂
If you enable DHCP service on the topology then no.
If you don't use DHCP on the controller then yes.

Static IP via AP console port..
cset dhcp disable
cset ipaddr x.x.x.x
cset ipmask x.x.x.x
cset authip 1 x.x.x.x (=controller IP address for registration)
capply
csave

[Carlo_Alviar]

Do i need to put a stati IP on the AP? Please see image for network setup.

[Ronald_Dvorak]

sure