Check the performance of an AP depending on the power it recieves
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-20-2018 05:40 AM
Hi Guys
Is there a way to see what performance the AP gives depending on the power it receives.
I know the 3935 will transmit on 2x2 when it only gets 15w power and 4x4 on 25w.
But is there a place to confirm it is broadcasting at that either via the Gui on the controller or the CLI of the AP.
Regards
Is there a way to see what performance the AP gives depending on the power it receives.
I know the 3935 will transmit on 2x2 when it only gets 15w power and 4x4 on 25w.
But is there a place to confirm it is broadcasting at that either via the Gui on the controller or the CLI of the AP.
Regards
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-20-2018 07:35 AM
Hi Sam
Thanks for that.
I completely forgot about that......
Been a long 2 weeks.
Regards
Thanks for that.
I completely forgot about that......
Been a long 2 weeks.
Regards
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-20-2018 07:14 AM
Hi Cornel,
From the home screen on the GUI you are able to view AP's that are in low power mode in the health table.
Hope this helps.
Best regards,
Sam
From the home screen on the GUI you are able to view AP's that are in low power mode in the health table.
Hope this helps.
Best regards,
Sam
