This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Default Settings after Upgrade to the latest EWC code

Default Settings after Upgrade to the latest EWC code

Philipp_Tittman
New Contributor III

‎02-27-2017 12:45 PM

Hi community,

i had a problem after upgrading to the latest ewc code with virtual appliances. After a successful upgrade and the required reboot of the appliance, the ewc comes up with the default configuration. After a second reboot the right configuration is loaded. I had this problem on several customers (running different 10.xx. codes before) and was wondering if anyone else had similar issues.

Regards

Philipp
0 Kudos
2 REPLIES 2

Philipp_Tittman
New Contributor III

‎02-27-2017 03:02 PM

Hi Umut,

usually the second reboot is initiated immediately by the EWC, which wasn't in those cases. This was very confusing.

Regards
Philipp
0 Kudos

Umut_Aydin
Extreme Employee

‎02-27-2017 02:55 PM

Hi Philipp,

the EWC reboots always two times after a FW upgrade.
The 1'st for the firmware and the 2'nd for the Config.
You will see this on the Serial Console output.
This is FAD.

But if the EWC was up and you could connect to the webview ofthe EWC and the config doesn't exist and after a 2'nd full reboot the config came back this is not expecting behaviour.

Regards
Umut Aydin

0 Kudos
GTM-P2G8KFN