enterasys ap 3605 radios
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-29-2015 07:46 PM
I have a 3605 Enterasys AP installed, which uses a wireless controller. The AP was working, but now the controller says its Radios are OFF. However the AP still has an address, and the controller shows it as up. Does this mean the AP isn't getting enough power, or something else?
16 REPLIES 16
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-30-2015 01:12 PM
its not listed under active APs
but the controller doesn't show it as down
but the controller doesn't show it as down
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-30-2015 01:11 PM
If you use DHCP for the APs you'd also try to just delete the AP from the controller database.
I've seen some cases were the config wasn't synced to the AP.
I've seen some cases were the config wasn't synced to the AP.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-30-2015 01:09 PM
we dont use the dfs channels. i will look in the lop output if i can find it
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-30-2015 01:09 PM
Could you doublecheck whether the AP is connected to the home controller.
GUI > Reports > APs > active APs
Thx
GUI > Reports > APs > active APs
Thx
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-30-2015 12:32 PM
The 5 GHz radio could be disable if DFS is enabled and a radar is detect. But i think this should be seen in ap log. Have you looked what the ap log output says?
