cancel
Showing results for 
Search instead for 
Did you mean: 

Extreme Wireless Analytics

Extreme Wireless Analytics

Andre_Brits_Kan
Contributor II
Hi All

I recently upgraded my wireless controller to the new FW Version 10.11.01.0210
This new firmware includes L7 analytics and Policy with out the need for a separate Purview appliance setup.

Reading the help file:

The Applications by WLAN pie chart displays the top 5 application groups running on that WLAN. ExtremeWireless cycles through the active WLANS displaying statistics. To view detailed statistics, enable Application Visibility during the WLAN configuration; then, on the Home dashboard, click the displayed pie chart under Applications by WLAN. Or, click Enable Application Visibility from the Home dashboard.The controller and AP capture statistics for 31 pre-selected application groups. The top 5 application groups are displayed based on bytes and throughput over the last two-minute measuring period. The stats for each WLAN display for 30 seconds on a continuous cycle. Historical statistical data is available from ExtremeCloud™ and Extreme Application Analytics™

The last line revers to the historical stats being available in the Extreme Application analytics.

So the question do I have to configure the controller/AP in Oneview the same way that you configure the Purview appliance in Oneview??

Thx

Andre

1 REPLY 1

Ronald_Dvorak
Honored Contributor
I'd say that sentence mean that you need Purview (=Analytics) - so no history data if the controller is standalone without Extreme Management Center.

Where in the "Reports" section could I find the "Applications by WLAN" report - doens't make much sense to me that I'd only start that one from the dashboard.
GTM-P2G8KFN