I have an AP3825i that its rebooting!!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-09-2017 04:10 PM
Hello I have a problem with an AP3825i, it´s reboot sometimes but just it is down about 40 seconds. How can I run a diagnostic?
Regads.
Regads.
7 REPLIES 7
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-09-2017 05:56 PM
Noobs - I'd never connect my console via wireless, that would increase my ping/delay and affect my perfomance in online matches
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-09-2017 05:56 PM
We've run in to a similar issue on our campus. We currently only allow gaming systems on the wired network, so some students have tried bridging the gaming system to their laptop. The bridged connection triggers spanning tree on the AP port which would reboot the AP. The student's laptop would then associate with the next closest AP and it would cause that one to reboot. The student usually realizes that the hack won't work and would quickly delete the bridged connection. For those students who were more persistent, we would black list their laptop and wait for them to call our help desk complaining that they can't get on the wireless network..
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-09-2017 04:33 PM
Check to see how many spanning tree topology changes you have on your network. If the counter is incrementing quickly, that could potential he be a cause of your issues.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-09-2017 04:31 PM
I had an AP that would go out occasionally. It would power off and then start backup.
Turns out spanning tree was turning the WIFI AP port off (including the POE power). A student had used his consumer AP and bridged the WiFi and plugged it into the wall creating a loop. Spanning tree was doing it's job.
Found it by comparing the MAC addresses and some sleuthing.
-Stephen
Turns out spanning tree was turning the WIFI AP port off (including the POE power). A student had used his consumer AP and bridged the WiFi and plugged it into the wall creating a loop. Spanning tree was doing it's job.
Found it by comparing the MAC addresses and some sleuthing.
-Stephen
