Identifi v 9.21.04

[Luis_Mendes]

When i deploy this firmware and enable port mirror(esa1 or esa2) the interface going down With c5210

[Doug]

If you are still having issues I would contact the GTAC and start a ticket for review.

Regards,

Doug

[Doug]

eth1 Link encap:Ethernet HWaddr 00:1E:67:57:51:1F

Settings for eth1: Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: d
Current message level: 0x00000007 (7)
Link detected: yes

[Doug]

netflow-mirror snmp-traffic-mirrorn-idx 1
netflow-export-dest "192.168.10.110"
netflow-export-interval 60
traffic-mirror-firstn 15
traffic-mirror-l2port esa0

Status Enable Port MAC Untagged Vlan Tagged Vlan
UP enable esa0 00:1E:67:57:51:1F
UP enable esa1 00:1E:67:57:51:20 999
DOWN enable esa2 00:1E:67:5B:8A:6C
DOWN enable esa3 00:1E:67:5B:8A:6D
DOWN enable lag1 00:1E:67:57:51:20
DOWN enable lag2 00:1E:67:57:51:20
DOWN enable admin 00:1E:67:57:51:1E

[Doug]

Tested and confirmed on 9.21.04 that the port is staying up when directly connected to ESA0, again no topology settings are applied to that mirror port.