shell command to check ARP table

[Ronald_Dvorak]

Hi,

I just troubleshoot a problem and need the command to check the ARP table of the controller.

#arp doesn't give me much info...

root@XXX:~# arpAddress HWtype HWaddress Flags Mask Iface
10.4.103.254 ether 00:00:0c:07:ac:00 C eth0
10.4.103.251 ether 78:2b:cb:3a:90:c9 C eth0
10.4.103.223 ether 00:22:4d:67:f3:91 C eth0
10.4.103.224 (incomplete) eth0
root@XXX:~#

I'd need it to check the MAC/IP of the APs on a bridge@EWC interface.

Thanks,
Ron

[Ronald_Dvorak]

Thanks Doug,

here my ticket# 01180187

-Ron

[Doug]

I don't specifically know of a command to grab the arp table for the esa port, it's not something we expose via the shell. If you do need this, you should open a GTAC ticket. Shell commands are used for support and debugging so we typically wouldn't post them here on a public forum.

Regards,

Doug