404 Error after upgrading AP4532 from WiNG 5.5 to 5.7

[Eric_Burke]

For testing of newer WiNG platform, removed 3 AP's from production (5.5) and factory reset them. Then updated one to 5.7, thinking I'd make it a controller and test with the other two (4522). After the upgrade, when I try to hit the web interface to set it up - I simply get a 404 error on https. Any thoughts? Did I break the internet?

[BigRic]

Thanks Chris. Seems that the older 5432 does not support standalone. And I'm not not mistaken, now that I've moved forward I can't go back to 5.5. The units used to support 12 (maybe 24) AP's as controllers. Maybe not anymore. Now I'm lost. I only updated this one, as i was planning to use it as the controller.

[BigRic]

Just tried from another machine and same issue (sorry, logged in under another account as FB does not work from this one). Source shows nothing:

404 - Not Found

[Orson_Joseph]

Hi Eric,

Here is a few things you can try.

Try using a different web browser

Make sure you are using https.

From the CLI, make sure https or http is enable in the management.

Regards,

Orson