Access Point still showing on Wireless Controller as offline after being physically removed (WM3400 & AP4600)
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-03-2015 02:47 PM
I'm currently using a WM3400 with AP4600s. (4620 in this case) We removed the AP4620 and replaced it, however it still appears on the web interface as offline. Is there a way to remove this AP from the controller so that others won't panic when they see the interface?
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-03-2015 05:23 PM
Thanks.  It was still there after I ran the command. For some reason the AP still showed up in the Config tab at which point I realized there's a delete button.... /sigh I deleted it and then commit/write and it went away from the dashboard. Appreciate the help! You can close this ticket!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-03-2015 04:02 PM
Yes, you will need to commit the changes and then save the config.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-03-2015 03:25 PM
Do I need to write to memory or anything else?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-03-2015 03:08 PM
Hi Sean,
If you log into the CLI of the controller, then go into config mode, you can just do 'no ap4600 '. This will delete the device config for this AP.
-Brandon
If you log into the CLI of the controller, then go into config mode, you can just do 'no ap4600 '. This will delete the device config for this AP.
-Brandon
