AP 7161

[Wicaksono_Arief]

Hi All...
I have a question about Motorola Access Point 7161.
How to connect two device AP 7161 with 5GHz Frequency use WiNG 5.5 GUI ?

[Ondrej_Lepa]

Tuan,

please open support case via Extreme Portal or by sending email to our inbox and we will check.

Thank you,
Ondrej

[Tuan_Nguyen1]

Hello Ondrej Lepa

I have updated successfully fw 5.8.6.5 for Ap7161, I have configured mcx as guide but not successful, can you help me through skype or teamview?

Thank you very much

[NghiaT]

Hi Tuan Nguyen, can I have your contact? my email: nghiatm79@gmail.com

[Ondrej_Lepa]

Hello Tuan,

feel free to reach Portal page for WiNG Access Points (End of Sale)
If you are entitled to download from this page, you'll find following

Regards,
Ondrej

[Ondrej_Lepa]

Hi Wicaksono,

could you be a little more specific?
You are looking for a way to create wireless bridge between two APs, right?
For this we recommend to use MeshConnex policy (MCX) and map it as BSS1 on 5GHz enabled radio.

However I have WiNG 5.8 running the process is almost the same.
Go to Configuration - Wireless - MeshConnex Policy

Then under Configuration - Devices / Profile - Interfaces - Radio2 - WLAN / MESH mapping assign the MCX you created

If you need more details please refer to WiNG 5.5 Reference Guide or take a look into MeshConnex Overview document available under following link

Edit: Here is document for Virtual Controller environment

Regards,
Ondrej