Captive portal options in WiNG v5.9
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 04:08 AM
Hi,
I have VX9000 controller and extreme AP 7502, I have created 4 SSIDs(Students, Admin, Teachers, Guest)in the controller. I need to access the internet through created SSIDs.what are the steps needed to access the internet through created SSIDs?
Thanks
Niyas P
I have VX9000 controller and extreme AP 7502, I have created 4 SSIDs(Students, Admin, Teachers, Guest)in the controller. I need to access the internet through created SSIDs.what are the steps needed to access the internet through created SSIDs?
Thanks
Niyas P
27 REPLIES 27
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 12:29 PM
Hi Niyas,
change the mode to trunk, configure the native vlan as the untagged vlan, configure the list of vlans that you want to allow, and after create the virtual interfaces for those vlans.
change the mode to trunk, configure the native vlan as the untagged vlan, configure the list of vlans that you want to allow, and after create the virtual interfaces for those vlans.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 10:25 AM
Hi Nuno,
Please find the below screenshot,this is correct or not.my data VLAN is 18
Thanks
Niyas P
Please find the below screenshot,this is correct or not.my data VLAN is 18
Thanks
Niyas P
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 10:16 AM
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 09:45 AM
Hi Nuno,
My controller is running in VMware platform, so the server has only one ethernet port. when I log in to controller interface showing ge1,ge2,xge1 etc.how to find out connected GE port and how to enable data VLAN in GE port.
Thank you
My controller is running in VMware platform, so the server has only one ethernet port. when I log in to controller interface showing ge1,ge2,xge1 etc.how to find out connected GE port and how to enable data VLAN in GE port.
Thank you
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 09:34 AM
Hi Niyas
the vlan creation on the controller is done the same way as on the APs the only difference is that you'll be modifying the Controller profile and no the AP Profile, don't forget to also add the vlan on you virtual environment.
you can look at the same link posted before for the Nat Configuration.
the vlan creation on the controller is done the same way as on the APs the only difference is that you'll be modifying the Controller profile and no the AP Profile, don't forget to also add the vlan on you virtual environment.
you can look at the same link posted before for the Nat Configuration.
