- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-09-2021 09:47 AM
Hi,
Is there any command to change the personality of Universal AP from HiveOS to WiNG without on boarding to XIQ??
How to exit from service personnel mode if AP305C booted in to? As this AP required a special console cable that I currently didn't have.
Regards,
ARUN
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-09-2021 12:34 PM
Changing personality from HiveOS to WiNG is that it has to be done from within XIQ
How to switch Universal AP operational modes between HiveOS and WiNG
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-16-2023 07:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-25-2024 03:39 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-16-2023 07:22 AM
#_system boot-os WiNG
#reboot
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-25-2024 03:39 PM
Worked - Simple and straight forward,
Thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-12-2021 12:02 PM
i only have the cli command for changing from
wing to aerohive resp. identify to wing/aerohive
Wing > Aerohive
>enable
#operational-mode xiq-cloud force
>> AP boots into Aerohive OS automatically
Identify > Aerohive
- intermediate step to WiNG is needed
- then from WiNg to Aerohive
Identify > Wing
#cset personality distributed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-12-2021 07:22 AM
Hi Robert,
As per this we need to onboard the AP first to XIQ then only we can switch it to WiNG. I am asking for CLI command where I can directly switch from Cloud to WiNG without onboarding to XIQ from AP console, because onboarding is not possible where client has WiNG architecture.
