DVC with internal RADIUS
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-27-2021 03:17 AM
Hello!
APs - AP310i with VC with internal RADIUS.
Redundancy working fine - after failure control is normally transferred to the backup controller.
But after re-election of the controller, the RADIUS server policy activation checkbox is reset (Activate RADIUS Server Policy).
As a consequence, there is a problem with authentication using 802.1x
After checking the checkbox and saving the config, everything works again.

Any ideas how to resolve this issue?
Thank you!
APs - AP310i with VC with internal RADIUS.
Redundancy working fine - after failure control is normally transferred to the backup controller.
But after re-election of the controller, the RADIUS server policy activation checkbox is reset (Activate RADIUS Server Policy).
As a consequence, there is a problem with authentication using 802.1x
After checking the checkbox and saving the config, everything works again.
Any ideas how to resolve this issue?
Thank you!
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-28-2021 11:15 AM
Hi,
I would suggest that you check the "Radius Server Policy" is applied on the AP310i System Profile and not the VC AP directly which will make it a device config limited only to that AP.
Regards,
Ovais
I would suggest that you check the "Radius Server Policy" is applied on the AP310i System Profile and not the VC AP directly which will make it a device config limited only to that AP.
Regards,
Ovais
