GUI Interface on AP7522E

[James_Forsyth]

I am unable to connect to the GUI on the access points connected to a VC, i can connect to the VC but one of the installation tests that we carry out is ensuring that we can browse to the non VC access points. It is an Express access point installation the firmware level is 5.8.5.0-016R

[Mevan_Liyanage]

you can re enable it using CLI

[Douglas_Novell]

Just to add you can check the status of the adopted APs from the VC by going to Configuration-Access Points. This should list all of the APs adopted and their 'online' or 'offline' status.

[Daniel_Mejia]

APs adopted by a VC are to be managed by the VC. Therefor GUI access to adopted APs is disabled.

[Christoph_S]

Bear in mind that you cannot make any config changes to Express APs from CLI.