Hello,
A site has some AP7562s. Some are no mesh, others are mesh points root and non root. They are adopted to a VX9000 with layer 3 level 2 links.
Are they all supposed to see each other via level 1 vlan links?
No mesh AP:
- has level 1 vlan links to all other APs except the non root ones
- can't ping non root APs
- can mint ping non roots APs
- mint route table shows all APs
Non root mesh AP:
- has level 1 vlan link only as self
- has level 1 mesh link and it's root AP as neighbour
- can't ping any other AP (but can ping everything else)
- can mint ping other APs
- mint route table shows all APs
Relevant config:
rf-domain GNC
timezone Europe/Prague
country-code hr
use smart-rf-policy GNC-SMART-RF
channel-list dynamic
control-vlan 113
meshpoint GNC-Mesh-Point
meshid GNC-Mesh-ID
beacon-format mesh-point
control-vlan 113
allowed-vlans 112-113
security-mode psk
wpa2 psk 0 xxx
no root
profile ap7562 GNC-AP7562-MCX
interface radio2
placement outdoor
meshpoint GNC-Mesh-Point bss 1
interface ge1
switchport mode trunk
switchport trunk allowed vlan 112-113
switchport trunk native vlan 113
interface vlan113
ip address dhcp
ip dhcp client request options all
meshpoint-device GNC-Mesh-Point
preferred interface 5GHz
ap7562 XX-XX-XX-XX-XX-XX
use profile GNC-AP7562-MCX
use rf-domain GNC
hostname GNC-RAP06
meshpoint-device GNC-Mesh-Point
root
ap7562 XX-XX-XX-XX-XX-XX
use profile GNC-AP7562-MCX
use rf-domain GNC
hostname GNC-AP07
no rf-domain-manager capable
Thanks.
Best regards.
