VX9000 Initial setup with NAT and DHCP

[NetCat7]

Hello !

I'm running new installed VX9000 on VMware machine.

Does anybody have a sample config file with configuration where it works as NAT (interfaces ge1 to ge2) and DHCP server (on Ge2) for APs and CPEs (connected to those APs)?

Also when I add ethernet adapters to VM, it assigns MAC addresses only to Ge1 and Ge2. However I'm using VMXnet3 adapter type over 10G interfaces ! But even if I add 3 or more network adapters to my VM it is still not detected in XGe1,2,3,4 ports , but only on 2 adapters in Ge1&2 - checked "show interfaces".  

Thank you.

[NetCat7]

Yes, I know XIQ is considered a better solution that supports not only APs but also other networking devices.

However, my choice of WiNG instead is because of NAT and DHCP. If you familiar with WiNG and XIQ, can comment please below point:

1.On WiNG controller is possible to use it as NAT (one GE/XGE port translate Ip traffic to another GE/XGE port ) ? While on XIQ-C can't do this.

2.On WiNG possible to host DHCP server to provide Ip address for both APs and CPEs connected over APs.

3. Creating RF settings/domains and control CPEs access over wi-fi with "password" or in "guest" mode is possible on both WiNG and XIQ-C ?

Thank you.