VX9000 vs AP7602 config status: version-mismatch

[EDUARDOM]

Hi !
I have a VX900  with 7.7.0.0 firmware version, and 120 AP7602 with 5.9.1.11 firmware versión ( the latest one).

Tha AP can´t take any reconfiguration, every time i make a change or reconfiguration, the AP don´t do nothing. 

In the controller "interface", "system", "adopted devices" i get in the "config status" column the message:  version-mismatch

Thanks in advance

Eduardo M

[rmu]

relaxed adoption is supported from 5.9.1 
for wing 5 aps i would take the last possible 5.9
for wing 7 aps i would take the last 7.7

[EDUARDOM]

Thansk both !

 Yes, I we have 2 diffferent AP´s,  

1. AP7602   177 UNITS 
2. AP310      76 UNITS

We have 12 different RF-DOMAINS, but almost in all we have the 2 models in each rf-domain.
The last WiNG was a 5.8 version, and we try to upgrade to recognice and adopt the 7602, but we lost the configuration changes.

   Which version do you recommend to operate acceptable with both AP´s?

Tks.

Eduardo

[rmu]

hi eduardo

as already said, ap7602 is not supported in v7.

but there is a way to still use them > its called "relaxed adoption"

with this you are still able to adopt wing 5 aps to a wing 7 controller.

therefore you need to disable the version check on the controller side (at best in the profile)

command:
enforce-version adoption none


>> BUT BE AWARE

1. it is not allowed to put wing 5 and wing 7 aps into the same rf-domain > each version needs to have its on
2. i´m not sure if it is still supported by extreme

nr
richard

[Vedran_Jurak]

Your controller and APs are running different firmware, that's why you are unable to manage them.

AP7602 is not supported on WiNG 7 so you would have to downgrade the VX9000 to WiNG 5.

Are there any other APs adopted to the VX9000?

Surprisingly the AP7612 is supported on WiNG 7 but the AP7602 isn't eventhough they seem to be very similar devices.