I have a question about our NX5500 with WiNG 5.9
We have configured 3 VLANs with 2 of them working fine with a DHCP scope on a Juniper firewall. The 3rd VLAN has a DHCP scope on a Linksys router and this one is not performing consistently. We do get the occasional address if we're lucky but at least 75% of the request from a phone for instance fails.
Our partner has now implemented the following solution: it will let the AP's request a DHCP address on this VLAN and now all request are working fine.
But there's a drawback; now I can see the web-interface of all the AP7532's showing in a network scan. There's no danger as we cannot log on to the web-interface, luckily.
Would there be another solution to stabilize the DHCP service in this specific VLAN without serving the AP's an IP address?
How about adding a route in this specific VLAN to the gateway serving the DHCP addresses?
You're thoughts on this are very much appreciated.
