FAQs - Page 35 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

S-Series Temperature Sensor Access via SNMP

Article ID: 13261 Products S-Series Goals Is it possible to read the temperature sensors (13189) via SNMP? Solution Upgrade to firmware 7.21.01.0015 or higher. Release notes state, in the 'code:Firmware Changes and Enhancements' section: code:MIB...

S-Series f/w 7.03.03.0001 displays alternating Environmental Temperature Hot / Normal messages

Article ID: 13226 Products S-Series, firmware 7.01.03.0004 through 7.03.06.0004 Symptoms The system logs "code:hot" messages, then "code:normal" messages a short time later. Here is the syslog output ('code:show logging buffer') - in ascending se...

I/G/D/C/B/A-Series Use of the 'set logging default severity x' Command

Article ID: 14985 Products I-Series G-Series D-Series C5, C3, C2-Series B5, B3, B2-Series A4, A2-Series Goals Difference between the universal default severity and the application default severity. Effect of using the 'code:set logging default sev...

S-Series Reports Temperature as being "hot"

Article ID: 13189 Products S-Series Symptoms Syslog ('code:show logging buffer') or Fault Log ('code:show support') report that the environment is hot. For example: code:System[3]Environmental temperature is normal. code:System[3]Environmental t...

7100/S/N/K-Series ifOutMulticastPkts MIB displays Broadcast packets instead

Article ID: 16100 Products 7100-Series, firmware 7.91.02.0006 and lower S-Series, firmware 8.02.01.0012 and lower Matrix N-Series DFE, firmware 5.21.25 through 7.62.04.0002 K-Series, firmware 8.02.01.0012 and lower Symptoms code:OutMulticastPkts ...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN