FAQs - Page 39 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

DFE with Initialization Failure and "tRdy2Swtch" / "tDSrecv3" Errors

Article ID: 11183 Products Matrix N-Series DFE Changes A module was slot-inserted into a running system. Symptoms The module attempted to initialize, then rebooted itself, with these Fault Log (5101) messages: code:"Syslog Message, <code:0>cod...

HiPath Wireless Assistant RADIUS attributes needed in order to authenticate management level access

Article ID: 12497 Products HiPath, HiPath Wireless Assistant (Web GUI), RADIUS, Service-Type, Filter-ID Symptoms When using RADIUS Authentication under the Login Management option, a user cannot login as a Guest Portal Admin to create new Guest P...

HiPath AP 3610/3620 Resetting every 20 to 30 Seconds upon First Install

Article ID: 12610 Products AP3610, AP3620 Changes New install, or adding new Access Points (APs) to a HiPath Wireless Controller (HWC). Symptoms The AP resets every 20 to 30 seconds after it gets a DHCP address. Error message displayed on the A...

G/D/C/B/A-Series f/w 6.03 Use of the LLDP-MED Network-Policy TLV feature

Article ID: 12931 Products G-Series, firmware 6.03.00.0022 and higher D-Series, firmware 6.03.01.0008 and higher C5-Series, all firmware C3-Series, firmware 6.03.00.0022 and higher B5-Series, all firmware B3-Series, firmware 6.03.00.0022 and higher...

Enterasys Support for the LLDP and LLDP-MED Protocols

Article ID: 7573 Protocols/Features LLDP LLDP-MED Standards 802.1ab ANSI/TIA-1057 Goals Enterasys Support for the LLDP and LLDP-MED Protocols Cause 802.1ab is an IEEE (Institute of Electrical and Electronics Engineers) standard for link layer...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN