FAQs - Page 95 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

Proper Removal/Replacement of DFE N-series Modules

Article ID: 5036 Products Matrix N-Series DFE Goals Power down a DFE module Remove a DFE module from chassis Install a DFE module into a slot Swap DFE module slots for troubleshooting Recommended procedure to remove a DFE blade from a chassis Rec...

Using System Image Loader to Retrieve Logs after S/N/K-Series Blade Fails to Boot

Article ID: 14837 Products S-Series Matrix N-Series DFE K-Series Discussion If a blade fails to boot at any time and a red CPU LED is presented, it may not be advisable to attempt to reset and get a green CPU LED without further troubleshooting t...

How to use an Atlas FlexView to query the Matrix DFE Fault Log

Article ID: 5497 Products Netsight Atlas Console DFE Protocols/Features Flexview Fault log Message log Cause Multiple methods of querying the Matrix DFE Fault Log are described in 5101. This article discusses the use of a combination of a DFE...

Configuring Daylight Savings Time on the SecureStacks

Article ID: 5829 Products SecureStack C3 SecureStack C2 SecureStack B3 SecureStack B2 SecureStack A2 Commands 'show summertime' 'set summertime' Goals Configure Daylight Savings Time Sample configuration Cause SecureStack products have no def...

SNTP Status 'Other' while Server is 'Active', while routing with SecureStack C3/C2/B3

Article ID: 7709 Products SecureStack C3, 6.03.00.0022 and lower SecureStack C2, firmware 3.00.50 and higher SecureStack B3, firmware 1.01.01.0039 through 6.03.00.0022 Changes Enabled Routing. Enabled SNTP. Did not add a host IP address. Sympto...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN