Brocade VDX6740T ntp not synchronizing

[jderington]

We changed our NTP servers to a new address in our network. I changed all the network devices to this new server and they all have gotten the new time. We have mostly Cisco but we have 2 Brocade VDX6740T's and they will not receive the correct time. I have removed the old servers and added the 2 new ones but it's many hours off. Am I supposed to do anything to make it sync with the servers? I have included some show commands below that might help. Something that seems odd to me after looking it up is the "sh ntp status" output, it has LOCL, should that still be LOCL when it's synced with an NTP server?

code:

VDX6740T# sh run | inc ntp
ntp server 10.xx.x.10
ntp server 10.xx.x.12
VDX6740T# sh clock
rbridge-id 2: 2019-10-09 07:57:51 Europe/Berlin (at this time my computer says 11:43)
VDX6740T# sh ntp status
rbridge-id 2: active ntp server is LOCL
VDX6740T# 

Thanks in advance for the help!

[SamPirok]

Hi guys, I’m looking in to this for you to see if we can offer any insights. Could you tell me if you’re using management interfaces as source addresses or fabric virtual gateway global ve as a source interface?

[jderington]

Sorry no I didn’t. I’ve looked everywhere but it’s so hard to find anything about these switches. 

[sbromulo]

Hi, did you get a solution for your problem? I have the same problem here on my job… I did everything right but the ntp do not sync...