How to export the cfg file from x450-e to an x460 g2 switch
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-25-2016 07:22 PM
How to export the cfg file from x450-e to an x460 g2 switch
5 REPLIES 5
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-25-2016 09:08 PM
Could be some other things that are handled a bit different to such as acl's or policy's.. Drew is correct as safest bet would be to past old to new 5 or 6 lines at a time checking for errors... If your port numbers don't match up you just have to compare how they are configured and change the config accordingly.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-25-2016 07:54 PM
so this will work going from a x450-e to the new 460 g2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-25-2016 07:54 PM
You shouldn't have any trouble with this. I would recommend scrolling through the config and confirm your port numbers are correct. The X450e had "combo ports" whereas the X460-G2 does not. Port numbers for any XGM modules will not be the same for the VIMs on the X460-G2.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-25-2016 07:38 PM
Method 1 in this article is what Brandon is talking about.
https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-copy-a-configuration-to-a-new-switc...
https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-copy-a-configuration-to-a-new-switc...
