cancel
Showing results for 
Search instead for 
Did you mean: 

Support for running XIQ software or appliances on Nutanix AHV hypervisor

Support for running XIQ software or appliances on Nutanix AHV hypervisor

wprather
New Contributor

I'm a sales engineer on the data center side and ran into this today.  Had to do a little research... 

Officially, it appears Extreme Networks doesn't support running their appliances on Nutanix AHV.  AHV is actually a derivative of Redhat KVM, so if it will run on KVM (usually a QCOW image), it will likely run on AHV, or can be configured to.  It is *supported* to run the appliances on ESX or HyperV or KVM, I believe.

My question is - If I just build a new VM on AHV with the right specs, running a compatible linux distro, can't I just install the XIQ SiteEngine and XIQ Controller apps on them and treat them well?  Is this supported?  Is the functionality the same?

Thank you for any help.

-wes

1 ACCEPTED SOLUTION

Hi.

See the ExtremeCloud™ IQ Site Engine, ExtremeControl®, and ExtremeAnalytics®Virtual Engine Installation Guide. The most recent version of the document can be found at the ExtremeCloud IQ Site Engine Documentation site. Select Installation Guide > Virtual Engine Installation Guide at the top of the page.

Sincerely yours

 

Regards Zdeněk Pala

View solution in original post

3 REPLIES 3

rortega
New Contributor

HI Zdeněk do you have any documentation about ExtremeControl running on Nutanix???
Best regards!

Hi.

See the ExtremeCloud™ IQ Site Engine, ExtremeControl®, and ExtremeAnalytics®Virtual Engine Installation Guide. The most recent version of the document can be found at the ExtremeCloud IQ Site Engine Documentation site. Select Installation Guide > Virtual Engine Installation Guide at the top of the page.

Sincerely yours

 

Regards Zdeněk Pala

Zdeněk_Pala
Extreme Employee

ExtremCloud IQ - Site Engine & ExtremeControl & Extreme Analytics are Nutanix certified since version 24.10!

Sincerely yours

Regards Zdeněk Pala
GTM-P2G8KFN