Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-11-2015 07:01 PM
I had a switch "dissapear" from our network but it is still plugged in to the appropriate port. In short, the switch on that port has an IP, internet connectivity and packets can move between our vlans but I cannot ping the switch or the devices it's connected to. If I know the port and MAC, how do I look up it's IP from inside the extreme switch?
Solved! Go to Solution.
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-29-2018 01:26 PM
let me see if we can get a couple of things defined. First on the 800 that "disappeared" how were you managing it? Did you have an ip on that switch you were polling? if so then what does the route look like between your monitoring system and the 800? It has to share an ip to another switch/router somewhere for you to be able to manage it in the first place. If you were managing it from the management only port then the port that is connected to should be in a common broadcast domain/vlan that goes to your router interface or management subnet.. You should be able to look at that arp table and confirm you have an arp entry for the ip of the 800... I dont see how you would not know the ip of a device that you had been monitoring.
13 REPLIES 13
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-11-2015 07:34 PM
The other switch is an Enterasys 800 series so they do not share L3 management so show edp port returns nothing.
When you say "go to another switch and check the arp table" what do you mean? The main switch is a stack and this is an independent switch at a testing station. I've tried arp -a on the machine it's on and I only get the gateway address of the entire vlan and not the switch it's on.
When you say "go to another switch and check the arp table" what do you mean? The main switch is a stack and this is an independent switch at a testing station. I've tried arp -a on the machine it's on and I only get the gateway address of the entire vlan and not the switch it's on.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-11-2015 07:13 PM
Hey Ben,
You would want to run "show fdb" or "show fdb .
If this is an extreme switch on the other side, you can run "show edp"
You would want to run "show fdb
If this is an extreme switch on the other side, you can run "show edp"
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-11-2015 07:13 PM
try "show iparp " if there is an IP address on the vlan
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-11-2015 07:13 PM
"show fdb " gives me the mac addresses on that port but no IPs. "show fdb " also only returns the mac address as well as "show fdb ".
Is there another way?
Is there another way?
